When you’re working with machines, it is obvious that you are going to face problems. It is just about how you deal with them to completely get rid of them and continue your work. The Titan 850 Striping Machine is the top choice for small to medium-sized projects because it is portable and gives consistent output. But it is important to remember that even the most reliable machine can run into any sort of mechanical hiccups if you do not thoroughly maintain it.
In the article below, we are going to discuss what are some of the most common issues that operators face with this machine and how you can immediately fix them. Let’s dive into the details and help you get rid of the issues.
No Prime Issue
One of the most common problems that contractors face is that the gasoline engine is working but nothing is moving through the suction tube. It often happens because there is a check ball stuck. In the outlet and inlet housing, small balls work as one-way valves and if the paint dries inside, these balls stick to the seats and end up breaking the vacuum.
You should immediately remove the suction set and use a screwdriver to gently depress the ball to free it. If you’re unable to do it you should unscrew it completely and soak the assembly in a dedicated cleaner.
Pressure Fluctuations and Tailing
If you’re feeling like the lines are heavy or tail-like or the pressure is constantly fluctuating, know that the atomization is failing. It can be because of a clogged filter or because of worn-out spray tips. When the tip wears, the orifice becomes circular, and it needs more pressure than the pump can provide.
The fix for it is to check the gun filters right away. If the filters are clogged even a little bit your pressure will drop immediately. If cleaning is not helping you, then you should think about replacing that tip. It is important to understand that once the tips are gone no matter how much pressure you use, you will not be able to fix the pattern.
Oversprayed Lines
If you are a contractor, you must have gone through a situation where the lines look really foggy or they do not have the required sharpness. If it is happening, you’re definitely dealing with turbulence. It can happen because you are operating the machine at the maximum pressure. If you also think more is better, you are wrong because high pressure causes paint particles to bounce off the surface.
You can fix this problem by dialing the pressure back. You must use the minimum amount of pressure that is required to get an accurate fan pattern.
Line Fading or Delayed Triggering
If the line is not starting where you want to or the paint feels really weak at the start of a pull, it can be because of loose cable tension. With time, the trigger cable on the handle can stretch, and it can cause this issue.
What you need to do is locate the barrel adjuster present on the cable. You have to then tighten it until the trigger engages the moment you’re pulling the lever. There should absolutely be no space in the handle if you want to get precision.
Professional Maintenance Schedule for the Titan 850
We know that many people are not aware of what their maintenance schedule for the Titan 850 Striping Machine should be, and that is what we’re going to guide you about below.
- You should try to clean the gun filter and check the suction nut every single day if you want to get optimal performance.
- You should inspect the front caster on a weekly basis to ensure the machine pulls a straight line.
- You should check the belt tension on a monthly basis because otherwise you can face RPM loss and also a lower GPM.
- You should also replace the diaphragm yearly because it can lose elasticity with time, and this will reduce the overall pump power.
In Conclusion
Just as we have stated above, if you’re working with a machine, it is definite that you are going to face some issues with it. But instead of ignoring these problems, you should try to fix them by paying attention to their maintenance because it will save you time and money.
You just have to make sure that you are taking proper care of your Titan 850 Striping Machine, and you will see how it is going to last you for years without any problem.